TH series of bucket elevator is the upgrading product of the HL-bucket elevator.Compared with HL type.TH type of elevator possesses the advantages of larger transmission capacity,higher degree,more stable and reliable operation and longer lift and so on.Main technical performance parameters meet the national standard.
The structure and feature of TH series of bucket elevator
(1)The capacity of the bucket closes to the actual volume of filling,plus the speed increases,the conveying capacity increases nearly coubled than that of the same bucket ofthe HL as follows.
(2)Top and bottom sprockets use assembly structure to facilitate the replacement flange and to low maintenance costs.
(3)The lower part uses tensioning device with a heavy hammer leveraged style that automatically maintain a constant tension,avoid slipping or falling off linked chain so that itis conducive to normal operation.
(4)Traction is linked to high-intensity ring .Affer heat treatment,it has a high tensile strength and wears resistance and therefore it keep a long life.
The model of material bucket and material-handling methods TH series of bucket elevator. The conveyor bucket comprises to bucket type ;ZH medium-deep bucket is generally applied for the distribution of wet,stick materials and materials that are so difficult to thrown out ,such as Green,sand,fertilizer,alkali powder,clay,etc,SH deep bucket is generally applied for distribution of dry ,loose materials and materials that are easily thrown out ,such as gravel,lump coal,cement raw materials,cement and slag,etc.
The conveyor bucket is for machine-loading mixed or gravity unloading .It is applied to transfer small pieces of powdery and low pondering type of materials of which packing density is less than 1.5t/m3 and humidity is not more than 250℃.The main technical parameters are shown in the following talble.
提升机型号Elevator Model |
TH315 |
TH400 |
TH500 |
TH630 |
料斗型号Bucket Model |
Zh |
Sh |
Zh |
Sh |
Zh |
Sh |
Zh |
Sh |
输送量Conveying capacity |
m3/h |
35 |
59 |
58 |
94 |
73 |
118 |
114 |
185 |
料斗Hopper |
斗容Bucket capacity |
L |
3.75 |
6 |
5.9 |
9.5 |
9.3 |
15 |
14.6 |
23.6 |
斗距Bucket distance |
mm |
512 |
250 |
链条Chain |
圆钢直径×节距Diameter of round bar×Pitch |
mm |
F18×64 |
F22×86 |
单条破断强度Single breaking strength |
KN |
≥320 |
≥480 |
料斗运行速度Bucket speed |
m/s |
1.4 |
1.5 |
传动链动转速Transmission sprocket speed |
rmp |
42.5 |
37.6 |
35.3 |
31.8 |
输送物料最大块度The largest block of materials |
mm |
35 |
40 |
50 |
60 |
注:表中斗容为斗盛水时容积,与实际填充量相近,故输送量计算时未考填充系数Y,具体选型时应根据物料特性求得Y修正值,以此修正计算机输送量. NOTE;Because the bucket capacity in the table is equal to volume of water filled in it and is similar to the filling,in terms of transportation volume,the filling coefficient y is not taken into account.Your selection should be based on the specific characteristics of materials and obtain y revised,and then calculate the volume. |